Torch Light Kit with Wall Mount & 1x1 Brick Lamp (20x)

Inspired by the Classic Space building sets of the '70s and '80s, faithfully upscaled 2000% (20x) from the original piece.

This is the full set: the torch, a minifig hand and arm wall mount, and a translucent 1x1 round brick with an LED light, at a bundle price (about 20% less than buying the pieces separately). Just pick your colors from the menus. At 20x it measures about 17 inches tall.

You can mount a piece to the wall using a minifig-inspired hand and arm.
Fasten the arm to a wall, and then slide the hand into the arm until you feel a satisfying click. Then you can snap your piece into the hand, just like the originals!

PLEASE NOTE:
Be gentle when removing the hand from the arm once it's attached; it's a very firm fit. If you pull it too hard too quickly, you could accidentally take the arm with it, depending on how you've fastened it.
My suggestion would be to hold the arm firmly against the wall while you gently twist and wiggle the hand out until it's free.
Using anchors, especially for the 20x line, is not a bad idea.

The 1x1s are printed in translucent PETG. After a lot of experimenting, I landed on a design with no visible infill, so light passes right through for a soft, colorful glow.

The LED puck light sits right inside the base of the 1x1 and comes with a remote, so you can change the color and brightness and run color-cycling effects. It's not bright enough to light a room or read by, but it's perfect for a little extra pop of color as an accent lamp or sconce.

The photos change with your "1x1 brick color" choice. The other menus aren't shown for every combination, so if you'd like to see a particular one, just send me a message.

To see how the hand and arm colors look together, check the color chart photo. It shows every pairing.

Check out the rest of the line in my shop: the torch, walkie talkie, video camera, wrench and metal detector, plus wall mounts, table stands and light-up 1x1 bricks and plates, in both 10x and 20x.

Every piece is printed and assembled by me, one at a time. Some pieces take a day or more of print time alone, so thanks for your patience!

A quick note on 3D printing: I work hard to make every piece look its best, but you may spot a few signs of the process, like layer lines, seams, or minor blemishes. Colors can also vary slightly from the photos.

Don't see the color you want? Custom colors are available on request. Just send me a message before you order and we'll figure it out.

These are display pieces, made to hang on a wall or sit on a shelf and be admired from across the room, not played with as toys. They're not as sturdy as their tiny counterparts, so please handle with care!

LEGO® is a trademark of the LEGO Group, which does not sponsor, authorize or endorse DG's Big Bricks. These are my own original 3D-printed designs, not LEGO products.